Other products by FlexoCleaners
Item #: UVSS
Reg. Price: $199.99 USD
Our Price: $189.00 USD
Unit Size  
  (min 1)



Looking for anilox cleaning products specially formulated for cleaning stubborn UV inks? Need something to come in and do the job that others can't? Try our UV Plus Strong & Safe anilox roll and ink cleaner. This super-concentrated, safe solution is packed with a blend of active, modern, environmentally-friendly cleaners. This chemical rich, concentrated formula is loaded with ink-attacking, cleaner safe solvents and powerful soaps. It is especially effective on problematic UV inks and water or solvent based inks as well. This is the all-in-one solution you have been looking for.


Mix at 1:1 with water for old, stubborn UV ink or as a periodic cleaner. For daily cleaning, mix 4:1 or higher dilution with water as conditions allow. Performs excellent in any ultrasonic cleaning tank or soak system. Effective and safe on both ceramic and chrome anilox rolls. Use to remove any type of ink from any anilox roll and as a general purpose cleaner. Use in tandem with our UV Plus anigel anilox cleaning gel to achieve best results. Try our strongest UV ink cleaner today! 

Use for in-press or off-press daily or periodic cleaning of any chrome or ceramic anilox roll. Start at full strength or 1:1 mixing ratio (1 gal. water to 1 gal. cleaner) for old, stubborn ink up to 4:1 (4 gal. water to 1 gal. cleaner) or a higher dilution as conditions allow. Spray or pour on any type of anilox roll, scrub with appropriate brush, then rinse off with water.


For use in an ultrasonic or soak tank anilox roll cleaning system, start at 1:1 to 4:1 or a higher dilution as conditions allow. For use as removing all inks as a general purpose cleaner, or for use on floors, countertops, stainless steel and other hard surfaces, start at full strength to 4:1 ratio and higher dilution as conditions allow.

For a complete mixing ratio chart please visit Mixing Ratio Calculator


For the best performing photopolymer plate cleaner available anywhere, try our Safety Clean Photopolymer Plate Cleaner.


Cleans wet and dried water-based inks, UV cured inks, solvent-based inks and adhesives, coatings and varnishes from any chrome or ceramic anilox roll and virtually any surface as a general purpose ink remover/cleaner.  

Water-based, water soluble formula, Appearance: clear liquid, Odor: minimal, pH concentrate=10.75, pH diluted 1:1=10.66, pH diluted 4:1=10.5, Total % VOC: 0.3% 
Readily biodegradable, environmentally-friendly, pH stable, non-corrosive, non-toxic, non-combustible, non-fuming, not Sara 313 listed, non-flammable, no flashpoint, no fire hazard, 0-flammability rating, non-ozone depleting, and low-aquatic toxicity. Contains no chlorinated solvents, no petroleum distillates, no EPA Hazardous Air Pollutants (HAP), no carcinogens, and no marine pollutants. Product contains no ingredient that causes carcinogenic effects, mutagenic effects, teratogenic effects, or developmental toxicity. Passes plate compatibility testing.


NFPA rating Health (NFPA): 1, Flammability: 0, Reactivity: 0.
HMIS rating Health(HMIS): 1, Flammability: 0, Reactivity: 0.
HS Tariff code: 3824.40.20.00